#Hp_tools partition full install#
#Hp_tools partition full update#

(I tried adding it in manually using EasyBCD, but it doesnt work either. Without this entry, it will not come into play even if its nicely installed, regardless of what you do to the BIOS, SysEdit, AutoExec or anything else. This seems to be because they dont have a way of adding an entry into the Boot Loader of Windows 7.

However, BOTH have one issue : They need to be installed BEFORE reinstalling windows. It has a configuration tool (in start menu shortcuts and in Control Panel). It allows installation on any drive you want, (including C) any format. It does not have a configuration tool either.

#Hp_tools partition full install#

The QW does not allow you to install on anything other than a separate, primary, FAT32 partition called HP_TOOLS. These 2 versions are the reason why there is so much confusion. One is the QuickWeb software, and the other a later version called Instant Web. Reinstall the program using the Recovery Manager, by completing the following steps.ClickВ StartВ ,В All ProgramsВ ,В Recovery ManagerВ ,В Recovery ManagerВ .SelectВ Software Program ReinstallationВ , and then selectВ NextВ .Select HP IOS, and then select Next. Reinstall missing IOS or QuickWebIf the IOS was previously configured and QuickWeb worked properly but has now stopped working, the program can be reinstalled using the HP Recovery Manager.

#Hp_tools partition full update#

Enable IOS in BIOSConfirm that IOS is enabled in the BIOS by completing the following steps.Power on the notebook and repeatedly presВ F10В to enter the BIOS setup utility.Use the right and left arrow keys to navigate to theВ System ConfigurationВ menu.Use the up and down arrow keys to navigate toВ Boot OptionsВ , and then press theВ enterВ key.Navigate toВ Instant-OnВ and selectВ EnabledВ .If desired, update the value forВ Delay to Boot WindowsВ .The HP IOS program is now enabled within the notebook BIOS utility.Д®nable QuickWeb in IOSConfirm that the IOS is configured to automatically launch within the Windows environment by completing the following steps.In the Windows environment, clickВ StartВ ,В All ProgramsВ ,В IOSВ ,В IOS Configuration ToolВ .SelectВ Enable IOSВ .If you choose to selectВ Enable OS countdown timerВ , set the timer to at least 10 seconds to allow enough time to use QuickWeb before Windows automatically loads.Back to top